Tabang!! Please...

[deathstar0818]

---

Unsa problem anang dili moDisplay na monitor pero naa siya power...ug ang system unit naa pud power...

[obemon]

Assuming you've checked all the cables & stuff...
-Have you got another monitor you can try? Try that first.

If no display on screen still then...
-It could be a faulty video card
-Could be a failing motherboard as well

Do you hear a sequence of beeps when powering up? If so..
-Coule be faulty RAM

My advice to you is consult your nearest technican. Goodluck.

[abloyboat]

try to remove everything naka taod sa board, clean them, tirahe ug contact cleaner, then install balik. try switch ON. kung problem gihapon, maybe defective board, video card, and/or RAM.

[abloyboat]

kung integrated ang video sa board, try ug gamit PCI video card. kung naay AGP slot mas nindot mag AGP video card.

[jo_hanks]

kung wala ana ila g pang ingon, cguro proc ang guba ana

[gtjr_ph]

unsay specs sa imong computer??

[warbrio]

proc? I think dili dayun basta2x maguba... most probably, its the motherboard or the Video Card... look for a friends then try your RAM, Video Card and Processor kung mahimo to theirs. If it all works, then it could be the motherboard. Try removing your motherboard and clean it, wash it with a fresh flowing water... ayaw na sa MCWD naa na chemicals sagul. Mas maayu kung sa deepwell, then dry it, use hair blower... Make sure it is all dry, ayaw jud pag bilin maski gamay tubig... Barbecue jud na imo MOBO. If you'r good in soldering and electronics... look for leeking Capacitor or Kanang Capacitor na ning burot ang ibabaw, try removing that then change it with the same value... gud luck pare


Get shocked and you'll get high

[2DC]

You will know it guba imo video card kay mo beep mana sya successively... most of the time one long beep tapos 2 short beeps.. i think... pro try lang to listen if there are any warning beeps when you boot up ur system. coz monitors dont break down that easily. so im guessing its with your other hardwares... check its your video card is placed correctly... i mean are the video card pins(the gold teeth) place properly into the video card slot? basin na luag ra... try lang remove the video card if its separate, and then place it back again. goodluck :mrgreen:

[warbrio]

Bai tan-awa ang brightness and contrast...

[rchyx]

ruzz, ung cable lang ng monitor ang problem ata.ung padung sa power supply...try to check. :mrgreen: