Swimming pool insulation method



There are several types of swimming pools that differ from each other in terms of size and purpose of their use. There are those who use them in their own homes and there are those who use them in sports clubs in order to teach swimming.


Since swimming pools are always full of water, water leaks must be detected periodically in order to preserve the infrastructure of the facilities and protect it from the great damage that may be exposed to it by isolating the swimming pools against water from the inside and outside to prevent water leaks from the body of the pool and thus protect it from Wear and tear. شركة إنشاء مسابح بالدمام



Swimming pool insulation method
Swimming Pool Insulation - Leakage Company
The swimming pool insulation method is done by insulation companies as follows:

Clean the swimming pools properly, making sure that there are no impurities or dust.
Laying a layer of high-quality tiles that are selected by highly qualified people.
Putting the putamen on cold, then putting the homes, and then thermal foam.
The use of the strongest types of welding, in order to weld between the joints.
Clean the isolated place and leave the isolation place clean.


The following is an illustrative example of a swimming pool waterproofing system:

Swimming Pool Insulation - Leakage Company
1- Cleaning concrete


2- Cement Corner


3- A primer for walls and floors.


4- The first layer of insulating bituminous coils.


5- The second layer of insulating bituminous coils.


6- A concrete floor protection layer of not less than 10 cm.


7- Reinforced concrete.


8- A protective layer for walls, bitumen reinforced sheets or fiberboards.
شركة تنظيف مسابح بالدمام





Other ways to insulate swimming pools:

Spray liquid bitumen onto the walls and floor and wait for it to dry.


Rolling out a layer of bitumen coil longitudinally with a ride (10 cm), and then welding that ride with fire, as a first layer.


Rolling out the second layer of the bitumen coil also, but crosswise with the same ride (10 cm), and weld it as well.
Then comes the last layer of aluminum foil before doing the insulation test.
Doing the insulation test for three days before doing the next stage, which is the tiles or ceramics.


There are those who put a layer of concrete to preserve and protect the insulation layer, then ceramic and finishing, but the most important thing is the following:

That the insulating layers contain a layer of concrete at the beginning for cleaning in addition to the presence of a cement angle at the bottom between the wall and the floor.
That there be a preparatory insulation layer, two layers of biotoxins rolls, and a protective layer of concrete or metal for the insulating layer.
That there be a protective layer for the insulating material for the walls and make sure of the quality of the ceramic that will be installed on the pool and the quality of its welds, which depend heavily on the efficiency of the worker who will perform the installation.
Also, make sure not to test the water in the pool before completing the filling process around the pool in order to be a factor for strengthening the pool and protecting the insulating layer from water pressure.
Swimming Pool Insulation - Leakage Company
عزل مسابح




Finally: It does not matter the way in which the insulation was made or installed, but the most important thing is that the water does not leak from the tank to the ground or from the ground to the tank and that the efficiency of the insulating material has a long period of continuity and does not lead to water leaks, with an emphasis on the need to detect leaks Water periodically on the swimming pool and its connections to ensure the safety of the waterproofing and thermal insulation and the absence of ground leaks of water around the pool.