I just got my 2TB Red drive a couple of months back and I decided to do a benchmark before I set it up on my NAS box as I was curious to see which would emerge faster.
This is not a comprehensive benchmark since I only used ATTO for disk benchmarks and FastCopy for real-world copying scenarios. I used FastCopy because it provides us with the time elapsed for the copy operation. I copied the installation folder of Diablo 3 (11GB) for this benchmark. Both drives were attached to the same SATA 3 port to be consistent (swapped after each test).
I also did the same tests on the WD 1TB Black drive after it was cleaned out. A second run was done after wiping the drive clean with a low level wipe.
For comparison, the specifications for the both drives are found here:
WD Black 1TB -
WD Black 1TB Specifications
WD Red 2TB -
WD Red 2TB Specifications
Here are the results for the 2TB Red drive.
ATTO (WD Red 2TB)
Fast Copy (WD Red 2TB)
Here are the results for the 1TB Black drive that was just formatted
ATTO (WD Black 1TB) - Drive formatted
Fast Copy (WD Black 1TB) - Drive formatted
Here are the results for the 1TB Black drive that was wiped clean
ATTO (WD Black 1TB) - low level wipe
Fast Copy (WD Black 1TB) - low level wipe
The test doesn't conclude much as we're comparing a 1TB Black drive against a 2TB Red drive but that's all I had at that time but it's interesting to note that the RED drive was much faster than the Black drive during the actual file copy scenarios.