Windows XP wont load...

[marcopolo]

---

Hi Guys.

Need help please. My winxp wont load. Kalit lang ni cya. Ining turn on nako sa CPU mu start ang system pero ining boot na sa sa windows xp dli cya mo load. Mag cge lang ug move ang status indicator. Usahay kay mag cge ug lihok ang status indicator then balik ug load sa sinugdanan. I had the hardware checked at PC express pero wlay guba. I tried reinstalling WinXp pero mao gihapon. Ako gi re format ang cpu then reinstalled winxp pero wla gihapon, tried using a diff copy of winxp pero still dli gihapon mo load. Ngano kaha ni? Need your advise. Thanks

[Utan_Tinunoan]

hmmm try lng ug load sa default bios settings. or try ug install lain nga OS like Ubuntu

[tasho]

different OS daw.

[marcopolo]

hmmm try lng ug load sa default bios settings. or try ug install lain nga OS like Ubuntu

mka dowload ra ta anang ubuntu bro?

[Utan_Tinunoan]

^oo bro. free rana ang Ubuntu. Linux system nang Ubuntu nga gidevelop sa mga banggiitang programmers sa Linux community ---> Homepage | Ubuntu

[bakasyunista]

wats ur OEM? run diagnostics

[diens]

bro try kuno kuhaa ang isa ka memory, basin daot ang isa ana, kun naa kay lancard nga dili built-in tagtanga pud or tanang card nga naka install sa imo pc kuha-a pud....din try on sa imo pc

[wire]

Hi Guys.

Need help please. My winxp wont load. Kalit lang ni cya. Ining turn on nako sa CPU mu start ang system pero ining boot na sa sa windows xp dli cya mo load. Mag cge lang ug move ang status indicator. Usahay kay mag cge ug lihok ang status indicator then balik ug load sa sinugdanan. I had the hardware checked at PC express pero wlay guba. I tried reinstalling WinXp pero mao gihapon. Ako gi re format ang cpu then reinstalled winxp pero wla gihapon, tried using a diff copy of winxp pero still dli gihapon mo load. Ngano kaha ni? Need your advise. Thanks

You know what? dili lang kay pag-daot sa mga technician sa PC Express huh? pero this is really obvious na hardware jud ang guba. Sometimes man gud kaning mga technician sa PC Express dili tarongon ug check or dili jud na sila kabalo mangita ug paagi. Klaro na kaaU na nga Hardware ang guba.

Bro, follow this steps:
1) reset all your BIOS settings to its factory default config.
2) back to bios.
3) check all the hardware info from the BIOS.

• Memory - was exactly pulled out the correct memory capacity?. Check you memory module. Solution: remove one of the memory and clean the pin by eraser. Now, take it the memory back to the slot one at a time. First, you must try booting your PC using 1 mem module. Go to the BIOS check the memory deatils and save. Then, boot up straight to the OS. Then shutdown and mount the other one. The Boot up straignt to the OS. If find it that would be the cause then one of your memory or all your memory is defective. You must change it with a good one.
  
• Processor - was your processor's temperature too high? have you tried to come close to the heatsink and touch? was it too hot? Solution: You may put some 'Silicon Paste' between processor & heatsink on a sandwich like direction. Make sure that the processor is properly mounted. This is probably a cause by an overheating.
  
• PSU - While the PSU is powered on along with its CPU load, you can get a tester and measure the voltage output and amper output from the PSU. That output should be satisfied according to the voltage and amper rating ratio or Power ratio.
  
• Motherboard - motherboard is easy to determine by swapping in and out with some new modules on different combination. if you may find something that you may think is not usual then that's it. but first this should be recorded along so you could have correct gathering of data for crosschecking between line to line. Motherboard is the last troubleshooting to be done must after the other.

4)Remove all your peripherals have plugged like printers, usb, etc...

Now, update us if you've done these things.


Hope this friendly instructions could help you a lot.

[marishelle]

i think need na siya og format.... i think na virusan na na xa

[ajboy13]

Basin naay problema imong RAM bro, pag try testing ug laing RAM.