Monitor problem or video card: how to know?

[madredrive]

---

My monitor suddenly waves like kanang mo gamay gani ... and usahay sad mo pawng pud xa ug kalit... nya mo on ra pud ug balik... nag libog ko unsaun pagkahibaw if sa monitor ni nag start or sa video card? onboard video card ra man gud ang na a nako diri sako mobo..

how to distinguish which is which

[nissanss]

most monitors i have seen is that when the signal cable gets disconnected from the cpu while (at least) the monitor is still on/powered, there's a flashing signal - 'no video signal detected'. u can try that to know f ur monitor is still ok.

[madredrive]

mau pud... na ka suway man ko anang ing ana.. kanang mo pawng man jd siya ug kalit bro.. kanang walay mo suwat na no signal or cable disconnected..
and inig pawng pud niya ug kalit ang monitor kanang ang iyang switch gani sa lower right mo blink blink man.. nya akong i pawng and on ug balik mau ra ghapon.. mau na ga libog ko asa ang defect ani..

[nissanss]

kung imo gyud gisulay nga gitangtang ang cable nya u'r not getting the full/stable display of d 'no video' signal i would say it's the monitor.

[xaired]

try lang brad, naa vc ka dibah tang tanga sa to ang builtin say padagana.

if naa japon, ehehe try lain vc. if naa japon basin ang imo jud monitor...

[akera]

go to BIOS, check if the problem is there... ug naa - monitor, ug wa - mobo... best to connect monitor to a known-good computer and check if same problem occurs

[madredrive]

try lang brad, naa vc ka dibah tang tanga sa to ang builtin say padagana.

if naa japon, ehehe try lain vc. if naa japon basin ang imo jud monitor...

on board man akong vc bro...

[o0ace0o]

kung naa man kay extra nah monitor nah sure ka ayu mau sa suwaye gamit nya observe

[madredrive]

kung naa man kay extra nah monitor nah sure ka ayu mau sa suwaye gamit nya observe

too bad i don't have any extra.. na a ba software na maka detect ani?

[cheezedog]

Sa monitor na cya bro. Replace Mosfet transistor inside ur monitor... = Solve