is 1.42v too high for cpu vcore?

[Kibir_Tidibir]

---

i read in another forum na taas ra daw ni xa na vcore(1.42)? im using athlon II x3...

[Sempron Guy]

depende sa processor but since you mentioned it, 1.42v is pretty much acceptable for your processor.

[Kibir_Tidibir]

what if i will lower the voltage bro? what are the cons? ana man gud to sila sa lain na forum na mu lower daw ang temps, sakto bah?

[werty]

Nominal Voltage is about 0.875-1.425V. WATCH OUT FOR THOSE TEMPS THOUGH!!!

undervolting does lowers temp. be sure lang its stable

[Sempron Guy]

naka overclock na imo processor? Sakto si werty ang importante dha ang heat. Ok ra na nga vcore if regulated imo temps. Bisan pa ubos ang vcore pero grabe kainit kana maoy naay chance maguba.

[Kibir_Tidibir]

wala man na ka OC ako procie sir, the cores idle at around 39-40 C... taas2x ra bah sir or ok ra? thats with stock HSF though... ill be installing a better HSF maybe tomorrow or this afternoon...hehehe

[werty]

max advised temp for cpu is 60degC
max advised temp for GPU is 90degC

ok ra molapas gamay sa mga suggested max basta pitik pitik lang...

[Kibir_Tidibir]

if e.lower nako ang voltage sir.. mga pila pud nako e-set? naka auto ra man gud ni sa ako bios...

[AMD_infinium05]

I bet you are using an ASUS BOARD?

[werty]

trial and error na sir...same as overclocking trial and error na sya kai depende jud na sa imo hardware....

i set mine to 1.2V(default 1.35) only kai mao ra support sa motherboard even if ma set nako lower sa bios. inig check it was always 1.2 bisan pila pa ako ibutang. but its stable. currently running 2.8GHz(264MHzx10.5) with Cool'n'Quite enable. temps ranges about 38-40 idle, 58-64 100% load.