Inquiry on Open LCS Set-up

[lloyd_joy]

---

peeps,

i'm here again asking for inputs... pros & cons are very much welcome... pwerte gyud nko pagka piti na mag Open LCS nko... hehehe... naa ko nakit-an dri na mga rads na 3 fans compatible, then naa man pud mapalit na mga add-ins (mounting pins) para ma install sya sa luyo sa chassis then naa'y hole pud ang akoang current chassis for the tubes that will be coming in from outseid... compatible sya sa ani na set-up. now, here are my questions to start the discussion...

1st, is it ideal to install the radiator outside the chassis? for sure, the one of the cons would be, the hassles whenever changing the set-up or adding more Open LCS component into the loop. but this is given man pud for an Open LCS... hassles is given on this type of cooling system...

2nd, is it acceptable to put 2 rads if it would be installed inside the chassis? let say, 1 rad (1x120 mm fan) installed at the back and other rad (2x120 mm fan) would be installed above the chassis...

i know that these set-up is an overkill kay pang uber OC naman ni... hehehe... but again, i would like to know the pros & cons ani nila...

salamat...

[jojobanana92400]

It would be nicer if you can put all your rads inside, But if gamay gyud ang imung case, there's no problem man sad. as long as you have sufficient cooling for you rad, but ma sacrfice lang ang looks sa imung case bec of the rads imung g put outside. and yes, its ok to put 1 120mm rad inside and 1 240 rad outside...

when it comes to changing or adding water t your system, I think same lang. if naa sa gawas or sud, because you should clean your wcs. every 6 months advisable, unsless you dont use any dye..

Good luck sa imung wcs.

[lloyd_joy]

thanks bro...

[lloyd_joy]

by the way, here are my rad choices... hinay2x-yon lang ni nako'g palit diri...


XSPC EX360


XSPC RX120


XSPC RX240

[lloyd_joy]

ask napud ko...

kita ko diri'g mga tubes... ang pinaka dako na size kay 13 x 19 mm... unsa man fittings/connectors ang compatible ani? mas preferred nko ang large tubings kay isog tan-awon... ug daghan pud fluids inig flow...


then, about sa coolant reservoir, kaning mounted sa 5.25" drive bays ba... ok ra ba ni sya gamiton? kita man ko dri ug mga locally made lang ba...barato lang man gud compared sa XSPC (500 rmb) then kaning locally made diri sa main land kay tag 230 rmb lang including the pump...

mao ni sila...

locally made... daghan nag gamit ani kuno dri sa main land. so far, so good man kuno. daghan ko na ask na seller ug users ani pud diri...



XSPC... proven gyud hinoon ni sya... no contest between the two...



thanks

[ren]

Tubing = 9.5 x 16mm = 3/8 5/8
Fittings = same size
Res/Pump = XSPC

Ngano na Beijing naman ni, diha diay Shanghai?

[lloyd_joy]

ah i see... surf2x lang sa ko bro sa taobao. wala man time mag laroy2x sa Xujiahui pa. bz kaayo sa work...

thanks bro