Pre-Selling Bnew PSU Voltage Tester... Pa reserve lang mo daan if interested kay limited stocks ra kada naay maabot...
Mid July ang next batch sa stocks... Pa reserve nalang mo daan... Please pm me for inquiries...
PSU Tester - PHP 1,600.00 - Fixed Price
*Note: Please know what you are buying. Compatibility and proper usage is buyer's responsibility. If you have nothing good to say, please stay out... And if you prefer other testers or testing processes, please open up another thread for discussion of your preference, this is not a competing thread... Thank you
Para sa mga nakapalit... Naay instruction sa ubos...
Instructions:
1. Plug your 24-pin and 4-pin/6-pin/8-pin connector into the Digital PC Power Tester.
2. Turn on your power supply unit.
3. The LCD screen will display voltage and PG value. You will also hear two short beeps.
4. Check your SATA and Molex power output connectors one at a time by plugging each into the Digital PC Power Tester’s corresponding input connectors.
The small green LED's will light up if the power output works. The LED's will not light up if the power output does not work.
Note: Do not plug two peripheral power outputs (floppy, SATA, peripheral) into the Digital PC Power Tester at the same time.
5. After testing your power, turn off your power supply unit before removing any connectors.
Abnormal Voltage Detection:
1. PG value
a. Power OK delay: 100ms<PG<500ms
b. When PG value is detected in the low 100ms or high 900ms, the Digital PC Power Tester will alarm and display a blinking “too low” or “too high” indicator.
2. Abnormal voltage (refer to table below)
a. When voltage is below “Low(A)”, an alarm will sound.
b. When voltage is higher than “High(B)”, an alarm will sound.
c. When voltage is lower than “Min(C)”, an alarm will sound and the screen will display “LL.”
d. When voltage is higher than “Max(D)”, an alarm will sound and the screen will display “HH.”
Pre-Selling PSU Tester
Reply With Quote
Posting Permissions
