Cannot See Other Computers in the WOrkgoup

**metdumangas** · 12-11-2005, 09:22 AM

Hi guys! A newbie here. How come I've installed windows xp on several computers, same workgroup, dili cla magkita? Any suggestions?

**AMD_infinium05** · 12-11-2005, 04:54 PM

how bout the ip configuration... unsa man

**AMD_infinium05** · 12-11-2005, 04:55 PM

and also check your firewalls... there are some firewalls that blocks net bios... chk pud imong windows xp firewall (sp2's)

**airosus** · 12-12-2005, 09:09 AM

try pud change to 10MBps full duplex or lower bro..

**tolstoi** · 12-12-2005, 09:17 AM

make sure all PC in the network are on the same "workgroup" or domain

**metdumangas** · 12-12-2005, 11:56 AM

Originally Posted by AMD_infinium05æ

how bout the ip configuration... unsa man

Same ip config, same workgroup.

**Creed-X** · 12-12-2005, 12:21 PM

IP must not be the same..Try using IP in consecutive order...

256.165.0.1
256.165.0.2
256.165.0.3
etc...

**sploy** · 12-12-2005, 03:55 PM

also don't forget to check if those computers that are not seen in the network are physically connected.. i.e. check the patchcord connection. and after doing the suggestion of Creed-X, try pinging the ip addresses of the computers if they reply or not... if not, then there really is a problem either physically disconnected, or just a on the ip addressing...

hope this helps...

**metdumangas** · 12-13-2005, 09:58 AM

Yes i know their ip addresses should not be the same. Mag ip conflict man kung pareho, d ba. And i can ping it, so dili patchcord connection ang problema.

**hombre** · 12-13-2005, 10:47 AM

install ipx/spx/netbios protocol... hth

Thread: Cannot See Other Computers in the WOrkgoup

Thread Tools

Search Thread