Akong PC meron problema!

[Vino Kid]

---

gatuyok pa imo CPU Fan?

basin overheat problem kay abog na ang CPU Heatsink.. just my thought.... :mrgreen:

[ruelnov]

Again, u cannot flash the BIOS in this situation 'coz the system cannot continue to boot to DOS.

The BIOS has to be detached from the board and reprogrammed somewhere else.

[digitalsuperman]

just buy another mobo.

[BayouPinoy]

Again, u cannot flash the BIOS in this situation 'coz the system cannot continue to boot to DOS.

The BIOS has to be detached from the board and reprogrammed somewhere else.

The suspected corrupt BIOS can be hot-flashed; and I agree with a previous post---get another mobo and save yourself a lot of valuable time. However, the CMOS resetting needs to be tried before giving up on the BIOS. The fact that you are getting different error codes based on removing some components suggests something is afoot and needs to be considered along with a possible corrupt BIOS. Edit: If you weren't fooling around with the BIOS before you ran into the boot problem, I really suspect the problem is elsewhere, else the system would be totally dead in the water. Run, skip, hop, and reset your CMOS and see what happens, and oh yeah, do tell what you fiddled with (on your mobo) before the problem started.

[Vino Kid]

yup try tabdog tandog sa connection basin ming luag na ang koneksyon, if else kung moinit or after hour of use mochange iya color basin some of the CRT components mingabot na ang edad like a capacitor, diode, regulator and other parts....

[jon]

problem change color? sa monitor na guba !!! uu guba jud . pa consulta sa specialista..

[bebie]

Try to Degauss it also and try doing what our fellow storyans suggest but if not

"My findings... uve got busted monitor. tryto look for a new one."

[metabo]

kung BLACK & WHITE imo monitor guba na sya! pero COLORED gani normal ra na...

[mc_2k5]

I'm an electronic technician, the problem of ur monitor is common, actually in most cases when monitor is on in a long period of time it will produce heat then this heat will cause some components nga maluag ang iyang sinuldahan. Sulayi ug pangita sa mga luag nga conponent sa mainboard then solder it, but if you are not qualified technician do not open your monitor bcause it will store high voltage especially in picture tube and plyback area just consult the right person to do that.

[Vino Kid]

I'm an electronic technician, the problem of ur monitor is common, actually in most cases when monitor is on in a long period of time it will produce heat then this heat will cause some components nga maluag ang iyang sinuldahan. Sulayi ug pangita sa mga luag nga conponent sa mainboard then solder it, but if you are not qualified technician do not open your monitor bcause it will store high voltage especially in picture tube and plyback area just consult the right person to do that.

yes that's true.......

hey, give the job to mc_2k5 basin barato ra iya pangayo pagpaayo sa monitor...... risky kaayo ang mag ukab sa likod sa monitor makilatan unya ka sa plyback xformer