Help Me "Windows failed to start. A recent hardware or software change might be the cause. |

[boylaang]

---

Windows failed to start. A recent hardware of software change might be the cause. To fix the problem:

1. Insert your windows installation disc and restart your computer.
2. Choose your language settings, and then click "Next."
3. Click "Repair your computer."

If you do not have this disc, contact your system administrator or computer manufacturer for assistance.

Status: 0xc000000f

Info: Boot selection failed because a required device is inaccessible.

pareha ani na error

http://www.tricksguide.com/wp-conten...0xc000000f.jpg

[jkhfg]

windows xp ni? naa ky windows CD?

[werty]

maka safe mode?

[domzgnrlover86]

Try This method TS basig masulbad ng problema mo

Repair the current OS using the Windows 2008 / 7 DVD:

1. Boot to the Windows DVD

2. Select Next > Repair your computer

3. Select Next > Command Prompt

4. Change directory (cd) to X:\sources\recovery, then type StartRep.exe to launch a quick automated startup repair utility which corrects boot environment values. This step may require more than one attempt and should be repeated a couple of times if the first repair fails.

5. If step 3 fails, open the command prompt and type bcdedit. This will display the values for Windows Boot Manager.

6. Review the values for Device. Is it set to unknown, as shown below? If so, proceed to step 7.



7. At the command prompt, type the following commands (c: is the default system partition. If your original partition was another drive letter, this value can be set to that drive letter):

bcdedit /set {DEFAULT.EN_US} device partition=c:

(press enter)

bcdedit /set {DEFAULT.EN_US} osdevice partition=c:

(press enter)

bcdedit /set {BOOTMGR.EN_US} device partition=c:

(press enter)

8. Reboot the system after removing the OS disk.

[boylaang]

windows 7 ni wla koy cd ani niya, know how jd ako ani

[reptoid]

Check your SATA cables, unplug and swap if necessary. Check your boot preferences in BIOS and make sure that the correct drive is selected as primary.

[Zacc]

tRY TO REPAIR yOUR wINDOWS OR FORMAT IT

[gaspar_73]

press F8 during booting,select safe mode,do a system restore....

[boylaang]

Check your SATA cables, unplug and swap if necessary. Check your boot preferences in BIOS and make sure that the correct drive is selected as primary.

mao tingale ni boss ky ky wla may primary ang iya hardisk detected as sata 1

[domzgnrlover86]

mao tingale ni boss ky ky wla may primary ang iya hardisk detected as sata 1

try to use another sata cable TS