Istorya Mobile Audio Enthusiasts (Diy, Tips, Faqs) Share your Car Audio System

[leurs]

---

up ta lang ni para sa pangutana ni l6y16w11........

[3raudio]

Maung buntag tanan!

Mga bos Pwd mu visit sa atong little shop here at 3R AUDIO-p.del Rosario ext.-(private road near caltex gas station)

I'd be glad to help all ur audio problems...

Peace...!!!

3R AUDIO

[bryan]

Sir asa gani na ang p.del rosario dapit?

[stanlee climbfall]

Got a Kia sportage 2007. Tried pa-burn mp3 CD pero wala gidawat sa disc player. Kato noon karaan nga music kay gidawat! FML

[bryan]

guys, any idea asa makapalit og inline noise suppressor? naa man gud ko noise madungan sa akoa speakers kung mogamit ko og other accessories like horns or fog lamps.
kanang parihas ani bah.
Amazon.com: Pyramid NS12 12 Amp InLine Noise Suppressor: Count Bishops: Car Electronics
or kani
Amazon.com: Scosche ES004 10 Amp 100-Watt Single Stage Noise Filter: Car Electronics

kung naa mo nahibal-an, please post diri asa mapalit og tagpila(kung naa mo idea).

salamat.

[merinoabs]

guys, any idea asa makapalit og inline noise suppressor? naa man gud ko noise madungan sa akoa speakers kung mogamit ko og other accessories like horns or fog lamps.
kanang parihas ani bah.
Amazon.com: Pyramid NS12 12 Amp InLine Noise Suppressor: Count Bishops: Car Electronics
or kani
Amazon.com: Scosche ES004 10 Amp 100-Watt Single Stage Noise Filter: Car Electronics

kung naa mo nahibal-an, please post diri asa mapalit og tagpila(kung naa mo idea).

salamat.

pwede ra capacitor ibutang ana bro.

[psyche54]

need help.... another newbie question. naa ko alpine mrv1507 (sensitivity 0dB to 12dB then ang frequency is 40Hz to 150Hz) which is mao ni iya connections pag set-up nako
channel 1&2 gi set nako ang sensitivity to 0dB nya ang frequency kay at the minimum nga 40Hz
channel 1 = tweeter
channel 2 = mid or high range speakers (2 pcs 100W 8" 8ohms) naapil ug butang sa box sa subwoofer (meaning ang sub naa sa front sa box then ang mid naa sa kilid sa box

channel 3&4 gi set pod nako ang sensitivity in the middle between 0dB to 12dB then ang frequency naa gihapon sa middle between 40Hz to 150Hz
channel 3 = sub (300W dual coil 10" sensitivity 95dB/W/M then ang frequency is 75Hz - 2.5KHz naka series iya connection)
channel 4 = same sa channel 3

The problem: Ok ra iya tingog kung hinay ang volume but kung pakusgan gamay kay mo barag jud ang bass bisan gamay ra open ang bass volume. Unsa mau buhaton nako ani? Ang akong na hunahunaan kay basi naa
1.) sayop akong connection
2.) sayop akong setting sa sensitivity ug frequency sa channel 3 & 4 (try na nako ug adjust at different levels) mo basag jud
2.) sayop akong box kay naipon nako ug butang ang mid.
3.) or dili kadaog akong speaker nga sub 2pcs.

Any comments and suggestions are very welcome and noted. thanks

Daghan kaayo ug irregularities ang imong setup sir..

First I would suggest you take note sa of the following:

Since imong Amp is 4 Channel Amp, try to see if bridgeable ba ang rear channel. In this way, if bridgeable you can get the max power from the bridged channel w/c is normally ang rear channels.. Then take note also of the Impedance of the amplifiers (1Ohm,2ohms,4ohms). And since I noticed that you have 8ohm drivers, sakto na nga giseries nimo ang duha to come up with 4ohms impedance.

Second is, does the amp do have built-in crossover (High Pass, Low Pass Filter or Pass Through). If the amp do have builtin crossover, then the simple thing to do is set channels 1&2 to high pass, and set channels 3&4 to Low Pass. Use passive crossover for your mid-range & tweeters. If you go active setup, then it's another story....

About high pass - low pass crossover settings. Sa low pass, w/c is basically dealing with lower notes (bass), try starting at 100Hz goin down wards until you find your sweet spot. Sa high pass pud nimo, try starting at the low pass point, then pasaka sad until makuha sad nimo imo gustong templa... Sometimes, ang uban i-overlapped ang high pass sa low pass (Low pass 80hz, high pass 63hz up), to bring in a little bit of kick in the front...

About sad sa mokorug ug pakusgan, there are certain factors pud nga kinahanglan tanawon. First thing is Level Matching. Is your amp's gain level matched with let us say 3/4 sa max volume sa imong headunit...

There are certain things that you need to check 'coz initially reading what you have described sir, mura na-mess up jud nimo imong setup...

[ejboi]

suroy nya mi dha sa CALTEX recle puhon

[bayawanon]

asa ta maka pa ayo sako clarion/pioneer car audio dili na xa mo fm/am, can't play cd and non of the buttons works. Only through usb rako mka play music niya.. asa ta maka pa ayo ani? kana affordable unta.. anyone??

[joco_ph]

muragn naa na sa cfg pero kanang noise suppresor, band aid solution ra na boss.

guys, any idea asa makapalit og inline noise suppressor? naa man gud ko noise madungan sa akoa speakers kung mogamit ko og other accessories like horns or fog lamps.
kanang parihas ani bah.
Amazon.com: Pyramid NS12 12 Amp InLine Noise Suppressor: Count Bishops: Car Electronics
or kani
Amazon.com: Scosche ES004 10 Amp 100-Watt Single Stage Noise Filter: Car Electronics

kung naa mo nahibal-an, please post diri asa mapalit og tagpila(kung naa mo idea).

salamat.