hala, paslaki nag bali 600w sad nga twetter para dli jud masunog. grabe pud au pakusog bisan basag na paminawon.
hala, paslaki nag bali 600w sad nga twetter para dli jud masunog. grabe pud au pakusog bisan basag na paminawon.
wala man cguro ni butangi Mylar ang tweeter unta capacitor ang midrange....600 watts man guro ni nga amp...
One of the causes nga maguba imong tweeter is kun grabe ang distortion ana nga amplifier. It's not because of the impedance sa tweeter being lower than that of the amplifier. kun impedance problem na, ang amplifier unta maguba.
Most likely, grabe ka kusug ang imong listening volume that the amplifier has gone clipping so grabe ang distortion. Usually, basta di maayo pagka-design ang amplifier pareha anang Sakura, grabe na mag-clipping at high volume because its power supply di makaagwanta sa demand sa power. So guba imong speaker especially the tweeter.
basin dili ka daog ang imo mid og tweeter sa ka kusog bro, awa ang ohms og watt, og gamay ra kay dili jud na pwede pa kusgan nimo. i think ang sakura kay 300watts or 500watts per channel.
Last edited by john_yo; 02-12-2010 at 10:39 AM.
A receiver claiming 120 watts per channel, with 10%THD is likely sitting on top of a piece of junk receiver which could hurt your speakers if you try to drive them loud. A quality manufacturer, like Denon, Pioneer, or Yamaha will prevent more than a couple of percent of distortion before shutting down the receiver to help protect your speakers.
The most common way to damage speakers is not by overdriving them with to powerful an amp, but turning up a weak amp way to much and under driving the speakers. __________________
You can read it at forums.audioholics.com
As per experience lang pud. . .
Makasunog or makaguba sad sa tweeters if masudlan siya ug bass frequencies.
Mao na nga butangan na siya ug condenser or any high-pass filter para dili mo sud bass frequencies sa tweeter.
Also, over-driving a tweeter could also cause it to fail. If ang imong tweeter, i-largo nimo tap sa speaker-output, hagtos gyud na!
_____________________________________
Pero, unsaon man nga 2006 pa man ni nga thread. Pila na kaha kagatos nga tweeters ang imong napalit, TS? ^+^
pwede singit og question?
ako amp nga 110v na paslak sa 220v ma ayo pani?
pag tanaw nako sa amp nako kay wala rabay fuse?
na sunod na dud ni noh?
2 things to check.....
1.)check imong tweeter ug midrange kung naa bay high pass filter (tawag nila na condenser or literally non polar capacitor).
2.) Check imong amp output terminal for dc voltage, 0.5mV to 1V cinsidered fatal sa imong load.
yeah ,basin wala nimo butange ug condenser imong tweeter and midrange giconnect ra nimo diretso sa output terminal sa amplifier. sunog jud na bro basta walay condenser bisan unsa pa na kadako ug wattage imong mid and tweeter.
sir.. if mo.tap gani ka ug tweeter or midrange kay butangi na ug 4.7 microfarad capacitor to ensure that the voltage output will not penetrate directly to the tweeter but instead sa capacitor mo.drop ang uban nga voltage..
Similar Threads |
|