DDR2 1.8V & 2.2V

[bryan]

---

Bros, pwede ba nako ma mix ang DDR2 nga 1.8V and 2.2V?

Say:

Slot 1: DDR2 667 1G 1.8V
Slot 2: DDR2 667 1G 2.2V

Slot3DR2 667 1G 1.8V
Slot4DR2 667 1G 2.2V

As you can see dual channel config ni. So, pwede bani? lahi-lahi og voltage?
Ako mobo naay nakabutang nga 1.8V ang DDR2 slots.

[cloud]

not quite so sure about that, check your manual. diff. voltages man gud. maybe not.
same lang seguro na sa mobo with SDR and DDR ram dili pwede.

[parts]

murag dle pwde bro....aw,,magamit pana nmo bro pero eventually,,naa jd mo bigay ana nila

[simoko]

ask lang ko bro...ngano lahi2x man ni sila voltage pareho raman unta sila freq(667) & size(1GB)? branded ang 1 of the pairs? normally man gud..1.8v na but can operate at 2.0-2.2V...kung mag oc ka naa time u need to raise the voltage sa imong dimms so mao na iyang 2.0-2.2v...

[ajol]

dili na pwede

[fish]

murag taas ra man nang 2.2 bro... akoa gani nga ddr2 1066mhz, 2.0v ra man gani akong gi-set. try to lower it down to 1.8, basin pwede, then you have your dual channels...

[bryan]

no no i didnt do any overclock/underclock.
Naa man gud baligya memories nga 2.2V, then naa pod 1.8V( note: DDR2 667 ni ang duha ha)

What im using today is 1.8V crucial. Naa man pod ko nakit-an nga baligya Crucial ballistix nga same jud tanan spec, voltage ra naglahi Which is.....2.2V.
Karon, pwede ba nako magamit ang 2.2V?

[EarlZ]

What brand of DDR2 is that requiring 2.2v at 667, most ddr2 modules that require 667 runs over 550fsb w/c is PC2-8800

[vladmire]

no no i didnt do any overclock/underclock.
Naa man gud baligya memories nga 2.2V, then naa pod 1.8V( note: DDR2 667 ni ang duha ha)

What im using today is 1.8V crucial. Naa man pod ko nakit-an nga baligya Crucial ballistix nga same jud tanan spec, voltage ra naglahi Which is.....2.2V.
Karon, pwede ba nako magamit ang 2.2V?

high performing modules imo gamiton? e-check lang imong mobo, usually ang mga mobo not designed for extreme tweaking cant support higher than 2.0v and above... mag-overheat rana... better consult the manual.

[EarlZ]

usually ang mga mobo not designed for extreme tweaking cant support higher than 2.0v and above... mag-overheat rana...

How does overheating relate to the motherboard not supporting 2.0v and above ?